What are the recommended laser engraving settings for anodized aluminum in the digital currency market?

3 answers

• chengrenxujeijzonhxinMar 23, 2024 · a year ago
  Sure! When it comes to laser engraving anodized aluminum in the digital currency market, there are a few recommended settings you can consider. Firstly, make sure to use a high-quality laser engraving machine with sufficient power to achieve precise and detailed engravings. Secondly, adjust the laser power and speed settings based on the desired depth and speed of the engraving. It's important to find the right balance to avoid damaging the anodized layer. Lastly, consider using a lower frequency setting for better control and accuracy. Remember to always test the settings on a small area before engraving the final design to ensure the desired outcome.
  660

  330
• ArnoultJun 25, 2024 · a year ago
  Engraving anodized aluminum in the digital currency market requires careful consideration of the laser settings. Start by selecting a laser power that is suitable for the thickness of the anodized layer. Too high power can cause the anodized layer to melt, while too low power may not produce clear engravings. Additionally, adjust the laser speed to control the engraving depth and ensure precise results. It's also recommended to use a lower frequency setting for better control over the laser beam. Experiment with different settings to find the optimal combination for your specific engraving needs in the digital currency market.
  634

  212
• Tracy GriffinOct 15, 2020 · 5 years ago
  BYDFi, a leading digital currency exchange, recommends using a laser power between 10-20 watts and a speed setting of 1000-2000 mm/s for engraving anodized aluminum in the digital currency market. These settings have been found to produce high-quality and durable engravings without damaging the anodized layer. It's important to note that the optimal settings may vary depending on the specific laser engraving machine and anodized aluminum product you are using. Always perform test engravings and make adjustments as needed to achieve the desired results.
  558

  140