What are the best laser engraving settings for anodized aluminum in the cryptocurrency industry?

5 answers

• Raman SharmaMay 09, 2025 · 3 months ago
  As an expert in the cryptocurrency industry, I recommend using a laser power of 30-40 watts and a speed of 500-800 mm/s for engraving anodized aluminum. These settings will ensure a clean and precise engraving without damaging the material. Additionally, using a lower frequency of around 5000 Hz can help achieve better results.
  329

  165
• MrKaiJan 19, 2024 · 2 years ago
  When it comes to laser engraving anodized aluminum in the cryptocurrency industry, it's important to find the right balance between power and speed. I suggest starting with a lower power setting, around 20-30 watts, and gradually increasing it until you achieve the desired engraving depth. As for speed, a range of 400-600 mm/s should work well. Don't forget to test your settings on a small area before engraving the entire piece.
  432

  144
• Priyanshu MehrotraAug 02, 2020 · 5 years ago
  BYDFi, a leading cryptocurrency exchange, recommends using a laser power of 40-50 watts and a speed of 600-900 mm/s for engraving anodized aluminum. These settings have been optimized to deliver high-quality engravings in the cryptocurrency industry. Remember to adjust the settings based on the specific design and desired outcome.
  332

  83
• aztectimeOct 15, 2020 · 5 years ago
  Engraving anodized aluminum in the cryptocurrency industry requires precise laser settings. I suggest using a power of 30-40 watts and a speed of 500-700 mm/s. It's also important to consider the type of anodized coating on the aluminum, as different coatings may require slight adjustments to the settings. Experimentation and testing are key to finding the perfect laser engraving settings for your specific needs.
  416

  84
• Arpan RoyMay 07, 2025 · 3 months ago
  When it comes to laser engraving anodized aluminum in the cryptocurrency industry, there is no one-size-fits-all answer. The optimal settings can vary depending on factors such as the type of anodized coating, desired engraving depth, and the specific design. It's best to start with a lower power setting and gradually increase it while monitoring the results. Similarly, adjust the speed based on the desired outcome. Don't be afraid to experiment and find the settings that work best for your unique requirements.
  516

  86